PowerEsim User Manual

Introduction

Start a Power Supply Design

Component Finder

Project Management

Loss Analysis

Waveform Analysis

Monte Carlo Analysis

Loop Analysis

Thermal Analysis

Life & MTBF Analysis

BOM - BOM Builder

DVT Reports

Magnetic Builder

Add Parts

Report Builder

Harmonic

EMI Analysis

Component Builder

Smart Optimizer

General Function in PowerEsim

Troubleshooting

PowerEsim Account Management

PowerEsim Terms of use

User Interface Practice

	Better Than Real - Free Switch Mode Power Supply Circuit (SMPS) Design Software & Transformer Calculation / Simulation Tool.
	PowerEsim User Manual

PowerEsim is a free web-based software providing power supply (SMPS) design, transformer design, magnetic design, loss analysis, thermal analysis, waveform analysis, MTBF analysis, BOM building, DVT analysis and optimization of power supply (SMPS). Click to try PowerEsim (www.powerEsim.com)

9.5.1 Top bar Back to top

With topology, there are additional features in the top bar.
For the original features, please refer to Session 9.3.7--Top bar.

9.5.1.1 Topology name Back to top

The topology name is shown at the top left corner of the interface.

9.5.1.2 Operating Condition Setting Back to top

If the user has initialized a design, the design specification will be shown at the top bar.

Users can change the T_a , V_in and I_o of the power supply. After modification, please click on "Recalculate" at the right to update the changes. Thermal results will then be changed.

9.5.1.3 Hidden Part Back to top

To hide a part in Thermal Analysis, click "Hidden Part" in the top bar.

A new window will then pop up.
To the right of the component list, check the box of the component that you want to hide.

Click [Apply] to apply the modification.