+  1 Introduction
 +  2 Start a Power Supply Design
 +  3 Component Finder
 +  4 Project Management
 +  5 Loss Analysis
 +  6 Waveform Analysis
 +  7 Monte Carlo Analysis
 +  8 Loop Analysis
 +  9 Thermal Analysis
 +  10 Life & MTBF Analysis
 +  11 BOM - BOM Builder
 +  12 DVT Reports
 +  13 Magnetic Builder
 +  14 Add Parts
 +  15 Report Builder
 +  16 Harmonic
 +  17 EMI Analysis
 +  18 Component Builder
 +  19 Smart Optimizer
 +  20 General Function in PowerEsim
      21 Troubleshooting
 +  22 PowerEsim Account Management
      23 PowerEsim Terms of use
 +  24 User Interface Practice
Better Than Real - Free Switch Mode Power Supply Circuit (SMPS) Design Software & Transformer Calculation / Simulation Tool.
PowerEsim User Manual
PowerEsim is a free web-based software providing power supply (SMPS) design, transformer design, magnetic design, loss analysis, thermal analysis, waveform analysis, MTBF analysis, BOM building, DVT analysis and optimization of power supply (SMPS). Click to try PowerEsim (www.powerEsim.com)




13.3.4.1.2.3.5 Winding Detail Back to top
Click on the "More" buttons for more details on winding.

There are two types of details on winding - "N0/N1/N2 detail" and "General".


13.3.4.1.2.3.5.1 N0 Detail Back to top
1. Click to change the number of turns and type of wire.

2. Click to change the settings of the winding N0,0 (similarly to change the setting of N0,1, N1 and N2)

  • When N0,0=N0,1, users can click the button, then click "ok" to change.

  • Click the drop-down menu on the right to change the order of the winding.

    • As shown below:

  • Click the arrow on the right to open "Advance Winding Construction" to change the detailed settings of winding, tape, upper and lower creepage width, creepage position and winding indent.

    • 3. Click to change split or parallel, and the number of windings.

    As shown below:


    13.3.4.1.2.3.5.2 General Back to top
    1. Click the arrow on the right to open the winding construction page.

    As shown below:

    2. Click the arrow on the right to add primary or secondary winding.

    3. Click the arrow on the right to add Faradary Shield to the primary or secondary winding.

    As shown below:

    4. Click the arrow on the right to change all wires.

    5. Click the arrow on the right to open flux band settings.

    As shown below:

    6. After changing settings, users can find the difference of winding.

    As shown below:



    Home | Download | Useful Link | Video Demo | About | Contact Us | Disclaimer | FAQ Statistics | Account Management | Options | Preferences | Help | Table of Content